Fowler 6399 'Fury'

The London Midland and Scottish Railway (LMS) No. 6399 Fury was an unsuccessful British experimental express passenger locomotive. The intention was to save fuel by using high-pressure steam, which is thermodynamically more efficient than low-pressure steam.

Built in 1929 by the NBL (North British Locomotive Company) in Glasgow, it was one of a number of steam locomotives built around the world in the search for "Superpower steam". The locomotive was a joint venture between the London, Midland and Scottish Railway (LMS), with Henry Fowler as Chief Mechanical Engineer (C.M.E.) and The Superheater Company with the latter having responsibility for constructing the complex, 3 stage Schmidt-based boiler. The LMS provided a Royal Scot frame and running gear. However, Carney [3] shows that the frames for Fury were not standard Royal Scot frames, but longer. For the complex boiler, John Brown & Company of Sheffield forged the special nickel-steel alloy high pressure drum and many boiler fittings were imported from Germany[5] but otherwise all manufacture was carried out by NBL

A 3-cylindered semi-compound compound locomotive, it had one high-pressure cylinder between the frames (11.5 inch bore) and two larger low-pressure outside cylinders (18 inch bore). The Schmidt steam-raising boiler was a 3-stage unit. The primary generator was a fully sealed ultra-high-pressure circuit working between 1400 and 1800 psi (9.7 to 12.4 MPa), filled with distilled water that transferred heat from the firebox to the high-pressure drum. This raised high-pressure steam at 900 psi (6.2 MPa) which was taken to power the cylinders and also recirculate pure water. The third steam raising unit was a relatively conventional locomotive fire tube boiler operating at 250 psi (1.7 MPa) heated by combustion gases from the coal fire. The engine was technically an "ultra-high pressure, semi-compound steam locomotive". It was given the LMS number 6399 and then inherited the name Fury from LMS 6138, which had itself been renamed in October 1929

After short runs during January 1930, a longer test run from Glasgow to Carstairs was scheduled for 10 February 1930. Approaching Carstairs station at slow speed, one of the ultra-high-pressure tubes burst and the escaping steam ejected the coal fire through the fire-hole door, killing Mr Lewis Schofield of the Superheater Company. Subsequently the burst tube was thoroughly investigated at Sheffield University but no definitive conclusion reached. The boiler was eventually repaired and Fury moved to Derby where a number of running trials were carried out until early 1934, mostly revealing significant shortcomings in performance. Fury's rods and linkages were then removed together with the indicator shelter and test gear when in 1935 it was rebuilt by William Stanier at Crewe Works with a more conventional type 2 boiler becoming 6170 British Legion, the first of the LMS 2 and 2A boilered 4-6-0 locomotives. Despite the accident, Fury was primarily an economic rather than a technological failure. Although tolerating the trials from Derby, Stanier didn't devote much effort to rectifying the faults Fury displayed, no doubt because of his many other work pressures and development of the LMS Turbomotive.[3] Nevertheless, Fury never earned revenue for the LMS and in fact "Fury must have travelled more miles under tow than under its own steam". As many other experimental locomotives showed, the theoretical benefits of ultra high steam pressure steam were hard to realise in practice

Courtesy Wikipedia



6399 Fury Derby works October 1932

https://railway-photography.smugmug.com/LMSSteam/Fowler-LMS-Locomotives/Fowler-Tender-Engines/NBL-Company-LMS-Fowler-6399-Fury/i-28wnMDb





Neil