Where does this bit go?

Currently working on a Shark Ballast Plough and starting to refit the Footboards.
2 boards per side 1 longer upper board and 1 shorter lower board.
Both supported by angled brackets riveted to the frame.
We marked up all the fittings with NE / NW / SE / SW as to which quarter of the vehicle they be longed, Thinking that would be good enough.
But no, the Hinges are ok and fit where they should as well as the Board support plate that the hinge piece sits on.
The only piece we have still to identify is the bit in the photo.
Approx 8 inch long with 4 holes drilled. Plate approx 1/8th thick.
There are 4 of them, 1 for each quarter.
There are no obvious bolt or screw holes in the boarding that match these plates.
Can anyone tell us what they are and where do they fit.

 

Sorry Bryan.....Not one on a 16T mineral!

 

Thanks anyway.

 

Don't the SVR have an operating Shark?. Perhaps you could contact their p/way department direct.

 

It is worth remembering, that SHARK is a codename for various diagrams of plough brakes.
Some have wheels between ploughs, some have ploughs between wheels.
I'm sure there are many other differences.

 

Ill have a look at ours on Friday if i get chance

Dave

 

That would be appreciated.

 

I’ve have a good look round ours and I can’t see anything that looks like that piece.

Dave

 

Breva came up with the answer and supplied us with photo's.
The bits were fitted on Tuesday this week. They fit on the lower stepboard Hinge side.
Thanks Breva